Green Tractor Talk banner

1 - 5 of 5 Posts

·
Registered
Joined
·
56 Posts
Discussion Starter #1
Hi guys,

I've got a RX63 that was given to me by a friend and I've installed new primary and secondary belts and I'm trying to adjust the clutch as per the manual and I'm just not quite sure if it's working properly. When I push on the clutch and move the gearshift from neutral into any gear (1 through 7) the machine will begin to slowly creep forward, and when I release the clutch the machine will begin to drive forward fine.

The question I have, is it normal for this forward creeping before releasing clutch pedal?

Thanks

T-Klash
 

·
Registered
Joined
·
56 Posts
Discussion Starter #2
Fixed,

Seems that with installing the new belts you have to break them in a little bit, just drove around the yard a bit warmed things up and then re:adjusted the clutch position again and that cured it.

T-Klash
 

·
Registered
Joined
·
56 Posts
Discussion Starter #4
1 - 5 of 5 Posts
Top