Green Tractor Talk banner

1 - 2 of 2 Posts

·
Registered
Joined
·
124 Posts
Discussion Starter #1
I have PB on a 4310 and 3046r. I have quick couplers on the wood chipper, but when connected, the lift arms/rock shaft flow are disabled. I can disconnect/reconnect quickly but it would be easier if there was a simple valve in which the PB implement and PB bypass connectors are connected and I can use the lift or implement by switching the valve.

What would be the easiest valve to use for this. It needs two female couplers/connectors for the output, and a male coupler for then inlet.
 

·
Registered
Joined
·
424 Posts
I think, if your woodsplitter isn't plumbed properly if attaching it to the PB port makes the rockshaft stop working entirely.. the rockshaft should only stop working while the woodsplitter is moving... otherwise, the fluid should flow through the splitter, and right back into the downstream end of the power beyond....
 
1 - 2 of 2 Posts
Top