Green Tractor Talk banner

1 - 7 of 7 Posts

·
Registered
Joined
·
58 Posts
Discussion Starter #1
Followed the lead of some others and built a stump/trenching bucket for my titan pallet fork frame.

Needs some cleanup and paint but on its maiden voyage it managed to pick 3 stumps (6” and less) and 6 lilac bushes in one hour.

Not bad for 100$ of steel. Biggest design flaw is straight sides as the dirt gets stuck in the bucket.

779956

779957

779958
 

·
Registered
Joined
·
481 Posts
How did you attach it to the Titan fork frame? ... (pictures please)
 

·
Registered
Joined
·
58 Posts
Discussion Starter #5
How did you attach it to the Titan fork frame? ... (pictures please)
Basically it hooks over the top like forks do and pins in on the outside of the receiver. I saw an older post with that attachment method so basically copied that. Simple enough and strong.

 

Attachments

·
Registered
Joined
·
270 Posts
Basically it hooks over the top like forks do and pins in on the outside of the receiver. I saw an older post with that attachment method so basically copied that. Simple enough and strong.

any concerns about forces being applied to mid span of the fork frame?
 

·
Registered
Joined
·
58 Posts
Discussion Starter #7
any concerns about forces being applied to mid span of the fork frame?
None whatsoever. I don’t think the tractor has that much power and the frame is pretty stout. I have a snow plow attached to the same points in the winter and no issues.
 
  • Like
Reactions: The Satch and bpop
1 - 7 of 7 Posts
Top