Green Tractor Talk banner

Thread Size and ID

1297 Views 6 Replies 4 Participants Last post by  ~JayK~
Hi,

I am trying to get some information relating to the thread ID and size for the handbrake adjustment hole on my JD2040s / 2140 tractor, as I need to put a hydraulic fitting into it to accept a return pipe from one of my implements. I know the plug is a taper thread, but that is all I know currently:

784002


If anyone knows what it is, then I would appreciate some input here.

Kind regards

Jay
1 - 1 of 1 Posts
Ditto the fittings I replaced in same location yrs ago were NPT.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top