Thread Size and ID
Hi,
I am trying to get some information relating to the thread ID and size for the handbrake adjustment hole on my JD2040s / 2140 tractor, as I need to put a hydraulic fitting into it to accept a return pipe from one of my implements. I know the plug is a taper thread, but that is all I know currently:
![784002]()
If anyone knows what it is, then I would appreciate some input here.
Kind regards
Jay
I am trying to get some information relating to the thread ID and size for the handbrake adjustment hole on my JD2040s / 2140 tractor, as I need to put a hydraulic fitting into it to accept a return pipe from one of my implements. I know the plug is a taper thread, but that is all I know currently:
If anyone knows what it is, then I would appreciate some input here.
Kind regards
Jay
1 - 3 of 3 Posts
Thank You, but do you know if the thread would be NPTF, ORFS, as it isn't BSP or JIC (I have tried 
)
)
Thanks All,
I will get some ordered and see where it takes me.
I will get some ordered and see where it takes me.
1 - 3 of 3 Posts
