Green Tractor Talk banner

Thread Size and ID

1296 6
Hi,

I am trying to get some information relating to the thread ID and size for the handbrake adjustment hole on my JD2040s / 2140 tractor, as I need to put a hydraulic fitting into it to accept a return pipe from one of my implements. I know the plug is a taper thread, but that is all I know currently:

784002


If anyone knows what it is, then I would appreciate some input here.

Kind regards

Jay
1 - 2 of 2 Posts
JD parts says it's a 1" pipe plug.
Photograph White Light Product Rectangle
  • Like
Reactions: rwmeyer
I'd say for that era tractor NPT. Since it will be dump to sump, I would not be too worried about leaks. I would use a paste type "pipe dope" just to seal from water entry.

I agree, do NOT use teflon tape any where on your tractor.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top