[Arsenix2001]

Just took delivery tonight and haven't had much time to look everything over but I did see something that set off my OCD. The 4th and 5th scv levers were no where near lined up. I peeked down into the connections and it appeared one lever was almost at the extent of adjustment and the other was about centered so it didn't seem like it's even possible for them to line up adjusting by the handle spindles. I did notice in this configuration it made it impossible for your hand to hit the other lever under operation while using instead of rubbing against the other lever which was nice. How is it supposed to be?

 

[Hammer30]

When I installed mine I lined them up and centered them. I'm am also ocd

 

[Old Machinist]

I would want both levers lined up with the center dot on the plate.

Have you run both through the range with the engine off? You might try taking the pressure off the system by moving the loader handle through it's ranges with the engine off then try both 4th and 5th levers.

 

[TSK575]

They are adjustable, I had to adjust them to center when I installed the 4th and 5th kit

 

[Arsenix2001]

Thanks, thats what I figured. Will tackle tomorrow.

 

[TSK575]

 

[Arsenix2001]

View attachment 811503

Awesome info! Thank you! Do you happen to know the spool location? Ill be home from work a bit later and can snoop around.

 

[TSK575]

Awesome info! Thank you! Do you happen to know the spool location? Ill be home from work a bit later and can snoop around.

 

[Arsenix2001]

View attachment 811515

You have no idea how much wasted time and headache you saved me. I was going to pull the console. All fixed Thanks so much.