Green Tractor Talk banner
1 - 4 of 4 Posts

· Registered
Joined
·
16 Posts
Discussion Starter · #1 ·
I'm trying to removed the auto connect mower deck from my 2020 1025r. I cannot release the left rocker lever (drivers side) to remove the deck. The right side is free and as expected. I'm on level ground, deck directly on ground, pto set to rear and followed the manual instructions, watched videos etc. This should be easy. What am I missing ? I'd appreciate the help

thank you
Garry
 

· Registered
Joined
·
16 Posts
Discussion Starter · #6 ·
Try pulling back towards the rear tire on the side giving trouble.
If that does not work try jacking up the back of the tractor just a little bit.
If you have any help there, have them continually check that lever for the pressure to release it while jacking it up slowly.

Bottom line if simply pully back on that side with the issue does not work, and jacking it up does, then it is not adjust properly.

Very common complaint around here. Dealers seldom take the time to setup the deck properly and much less double check that it actually comes on and off as it should.
That's been my intuition all along but will try jacking it up first and give that a try. gracias amigo.
 

· Registered
Joined
·
16 Posts
Discussion Starter · #7 ·
The mower mounting mechanisms changed in mid-2020. Do you know whether you have the "up to 2020-1/2" or the "after 2020-1/2 lift mechanism? Most of us here obviously have the older setup and will be of limited assistance to you. A few have the newer setup. If you have the newer one, help might be a little slow coming as the pool of experienced users is still small.
bought it in 2020 so I guess it's the former. Either way I'm very appreciative of you guys
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top