Green Tractor Talk banner

1 - 6 of 6 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter #1
Looking for a front quick hitch for a John Deere 425-445-455 series tractor. Would prefer nos or good used with both rams, but a single ram hitch would be OK.

THANKS!
 

·
Super Moderator
Joined
·
8,130 Posts
Looking for a front quick hitch for a John Deere 425-445-455 series tractor. Would prefer nos or good used with both rams, but a single ram hitch would be OK.

THANKS!
Poncho,

I don't have a front quick hitch for you but I do have a complete implement drive (front drive shaft) with up-stop, hardware and hydraulic hose extensions. This fits 425, 445, 455, 2210 & 2305. This is necessary to run a 47 or 54 blower or a front broom. New and in the box. Sells for about $300. Make an offer. I can supply photos if you'd like.

Best regards,
Frank
 

·
Registered
Joined
·
17 Posts
Discussion Starter #3 (Edited)
Poncho,

I don't have a front quick hitch for you but I do have a complete implement drive (front drive shaft) with up-stop, hardware and hydraulic hose extensions. This fits 425, 445, 455, 2210 & 2305. This is necessary to run a 47 or 54 blower or a front broom. New and in the box. Sells for about $300. Make an offer. I can supply photos if you'd like.

Best regards,
Frank
Hi Frank,

Thanks for your response. I recently picked up a NOS hitch for my 455. It was a little dusty, from sitting on the shelf, but cleaned up real nice. Even came with the lockout valve and other bits. I am looking for the hitch angle kit (BM17650) if you know of any. May be interested in your implement drive kit.....can you send me a photo?

Thanks!

Tom
 

·
Registered
Joined
·
11 Posts
Poncho,

I don't have a front quick hitch for you but I do have a complete implement drive (front drive shaft) with up-stop, hardware and hydraulic hose extensions. This fits 425, 445, 455, 2210 & 2305. This is necessary to run a 47 or 54 blower or a front broom. New and in the box. Sells for about $300. Make an offer. I can supply photos if you'd like.

Best regards,
Frank
Frank, I am interested in your front PTO kit for the 2305. Also your extension hoses.

Mark
 

·
Super Moderator
Joined
·
8,130 Posts
Frank, I am interested in your front PTO kit for the 2305. Also your extension hoses.

Mark
This isn't the mid-driveshaft or front bearing hangar. This is the front implement driveshaft, up-stop, hose extensions and hardware. See the attached photo.

Implement drive-2.jpg

PM me with any questions.

Thanks,
Frank
 

·
Registered
Joined
·
11 Posts
Quick Hitch

I have a Quick Hitch of of my 445 that is dual action. I also have the PTO shaft that runs from the rear differential to the front.

Mark
 
1 - 6 of 6 Posts
Top