Green Tractor Talk banner

1 - 5 of 5 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter #1 (Edited)
I have done and replaced just about every thing to get this to work.The blades will not engage. New key switch ,rio switch,black box under dash what ever you call it. It will engage if I direct wire it to clutch . Can you just put a toggle switch on it with out hurting any thing ? It starts fine but can not engage blades.
 

·
Registered
Joined
·
796 Posts
Have you checked the safety switches themselves (brake, reverse, seat)? The switches could be non-operational (stuck either in open or closed position), or out of adjustment to actuate. Do you have a VOM or DVOM (Volt Ohm Meter or Digital Volt Ohm Meter)? Test the switches on ohm range/diode/continuity - Open is infinite ohms or OL - Closed is 0 ohms
 

·
Registered
Joined
·
21 Posts
Discussion Starter #4
all switches work. can not check reverse switch. Found it. Can you just jump the 2 wires to disable it ?
 

·
Registered
Joined
·
21 Posts
Discussion Starter #5
Can you direct wire deck clutch to a toggle switch without hurting any thing ???:unknown::unknown:
 
1 - 5 of 5 Posts
Top