Green Tractor Talk banner
1 - 13 of 13 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
I've been using a x730 with a hc54 deck. The height adjustment knod work without the deck attached. When I put the deck on the height adjustment knod has no effect and the deck will drop to the ground and only lift s about three inches. What am I doing wrong?
 

·
Registered
Joined
·
392 Posts
Does the knob turn?
How do you know it is doing something good when there is no deck on?

My guess is the knob is stripped and not doing anything ever. You just think it is when the deck isn't on, because the arms don't have enough weight to go down by themselves.
 

·
Registered
Joined
·
8 Posts
Discussion Starter · #3 ·
I left the draft arms on the lift. I could see them moving. I also had the level adjust tool on the adjusting bolt. I could see the arms, and the wrench moving. They seemed to raise/ lower in conjunction with the height adjustment knob, but as soon as I attach the deck I get 3 inches of lift and the deck goes all the way to the ground? I must be missing something simple.
 

·
Registered
Joined
·
8 Posts
Discussion Starter · #6 ·
Wheel Automotive tire Tire Motor vehicle Tread

Tire Wheel Automotive tire Vehicle Tread

This is the extent of the travel. It will go a little higher but I had to mow so I set it where you see it. That is the travel I get with the deck on
 
1 - 13 of 13 Posts
Top