Green Tractor Talk banner
1 - 2 of 2 Posts

· Premium Member
Joined
·
10,273 Posts
I would think they would not be hard to have made. From your frame you could get the center to center of the two bolt holes that attach them to the frame and the hole size. All holes are for M12 bolts.
Once have the crossbar P/N WP612890, you could figure out the measurement for the single hole in the tab. Take the center to center off the crossbar. Subtract the width of the frame. Divide by two. This will be how far from the back side of the bracket to the center of the tab hole.
Since the bracket fits both left and right side, the tab hole will be centered between the two frame holes.

Another place to check is Europe. Try www.acrar.com They list it for 50,22 EUR
 

· Premium Member
Joined
·
10,273 Posts
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top