Green Tractor Talk banner

1 - 3 of 3 Posts

·
Registered
Joined
·
212 Posts
Discussion Starter #1
I seriously considering getting a front lift kit for my XUV590E (see pic). I got the instructions from the potential seller. However; the instructions must have been made in China cause I can’t make sense of it. The instructions do make clear that one end is attached on the top strut mount and other end attaches to chassis but fails to state where on chassis. I have vigorously searched the Internet for videos but zero luck. Will someone please help out with this? IMG_4263.jpg


Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
361 Posts
I seriously considering getting a front lift kit for my XUV590E (see pic). I got the instructions from the potential seller. However; the instructions must have been made in China cause I can’t make sense of it. The instructions do make clear that one end is attached on the top strut mount and other end attaches to chassis but fails to state where on chassis. I have vigorously searched the Internet for videos but zero luck. Will someone please help out with this? View attachment 690772


Sent from my iPhone using Tapatalk
I recently installed a lift by the same Manufacturer on my 825i.

I found the kit to be very high quality and easy to install. I was required to drill two hole ( one on each side) to bolt through the frame.

Hopefully this eases your mind on the quality?
 

·
Registered
Joined
·
212 Posts
Discussion Starter #3
I recently installed a lift by the same Manufacturer on my 825i.

I found the kit to be very high quality and easy to install. I was required to drill two hole ( one on each side) to bolt through the frame.

Hopefully this eases your mind on the quality?
Thank you! The instructions state nothing about drilling holes. I would think drilling into the chassis would void the warranty... is that right?


Sent from my iPhone using Tapatalk
 
1 - 3 of 3 Posts
Top