Three questions: in explanation:
I feel rather foolish asking questions like these and others I have posted, but to me the manual is fine, if you’re familiar with these tractors. Kind of like the Chilton’s manual for Cars.
Remove the domaflatche located above the Hodaki. Never explaining to a novice where the picture taken is located if there is even one. If there is a picture taken it’s so close up you can’t figure out where on the engine the Doma. or Hoda. is located. 🥵🥴
From what I can see (Maybe understand) in the operators manual the hydraulic oil and the transmission use the same oil.
1. Does the hydraulic oil and the transmission use the same oil?
2. If they are, I am assuming you only add Hyd. oil to the fill hole, centered above the top cylinder arm for both the transmission and the hydraulics. Is that correct? Fill hole arrowhead in the picture below.
3. Can someone please take a picture of the Site Glass for the Hyd. Oil. Far enough away that I can find where it is located. I do know what a Site Glass is and what it looks like. I read about people checking the site glass or adding dye so you can see it in the Site Glass. I can’t find anything anywhere in the operators manual that talks or shows a picture of a Site Glass.
🐺
![1699988280515-jpeg.930943.jpg]( "1699988280515-jpeg.930943.jpg")
I feel rather foolish asking questions like these and others I have posted, but to me the manual is fine, if you’re familiar with these tractors. Kind of like the Chilton’s manual for Cars.
Remove the domaflatche located above the Hodaki. Never explaining to a novice where the picture taken is located if there is even one. If there is a picture taken it’s so close up you can’t figure out where on the engine the Doma. or Hoda. is located. 🥵🥴
From what I can see (Maybe understand) in the operators manual the hydraulic oil and the transmission use the same oil.
1. Does the hydraulic oil and the transmission use the same oil?
2. If they are, I am assuming you only add Hyd. oil to the fill hole, centered above the top cylinder arm for both the transmission and the hydraulics. Is that correct? Fill hole arrowhead in the picture below.
3. Can someone please take a picture of the Site Glass for the Hyd. Oil. Far enough away that I can find where it is located. I do know what a Site Glass is and what it looks like. I read about people checking the site glass or adding dye so you can see it in the Site Glass. I can’t find anything anywhere in the operators manual that talks or shows a picture of a Site Glass.
🐺
