If you get the Mudd's deck stand, they include a vent plug to install before placing the deck on the stand. In the spring, remove the plug and put the vent back in. I have the Mudd's custom stand and it works very well.

 

I think Muud's Customs has the best set, for $150. But be prepared to wait for them given the demand for them.

Deck Stands

Pre orders will ship in 5-7 weeks Our deck stands will allow you to store your deck in a space saving vertical stance when used in conjunction with the JD Load N Go or MFG lifting device. Standard- 60D" fully welded and will have an angled gauge wheel spring pin (looking from top) Standard-...

muddscustoms.com

These are $50 less expensive, but don't swivel. I bought these first and had a difficult time maneuvering the deck around. Like I said, I would hold out for the Mudd's set. They (Larry's) do force you to push the deck from the safer ends, rather than the wide parts, so there is less risk of a turnover.

Moweraxle.com

www.moweraxle.com

 

My dealer warned that storing vertical can cause problems with the oil in the transfer case of the autoconnect mower decks. Anyone have experience with vertical storage that would support the warning?

 

Not limited to auto-connect, they all use the same gearbox. There is a vent on the gearbox that can weep lube when the deck is stored vertically. Some never have a problem, some develop it over time, etc. IMO, not really a big issue - check the gearbox oil level at the start of the season (especially if you notice a puddle under the deck) and add if necessary.

 

Is the deck Load n Go equipped, or do you need a Deck Dolly to lift it and move it with your own muscles without using the loader? Do you have a loader?

 

I do not have a load and go. I have a loader bucket I would use to lift it and put the rods and wheels on.

 

Thank you all.

 

Based on numerous posts here on the topic over he years, some folks have a leaky vent, and others do not. I am one of the lucky ones. If you have a leaky vent, just remove it for the winter and put a solid bolt in its place. As said, the Mudd's wheels come with a bolt, which is a nice touch. Just be sure you store the vented plug where you can find it in the Spring. Some folks wire it or zip tie it to the gearbox for storage.