I would like to change out the 45 degree grease zerk to a 90 degree on the mower end u joint, but cannot find the size in the manual. Does anyone know?
gumwrapper2002
I believe they are 10 mm but the best way to tell is to take out one of your fittings and match it up at the store.
It may depend on where your mower was made and what brand it is. Fittings can come in standard thread, metric thread and in pipe thread and in all different sizes. On some equipment they actually drive in.
Sorry I couldn't be more specific.
It may depend on where your mower was made and what brand it is. Fittings can come in standard thread, metric thread and in pipe thread and in all different sizes. On some equipment they actually drive in.
Sorry I couldn't be more specific.
At our jd dealer.....
Right at the counter......Assortment of grease fittings pre packaged.....All the angled ones and everything else.
There are 2
One is metric
the other american
I bought mine a few years ago.....maybe 10$ a pack then..I think less.
Its likely 15$ + but at the price of gas/diesel....Grab one of each and your all set
Right at the counter......Assortment of grease fittings pre packaged.....All the angled ones and everything else.
There are 2
One is metric
the other american
I bought mine a few years ago.....maybe 10$ a pack then..I think less.
Its likely 15$ + but at the price of gas/diesel....Grab one of each and your all set
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
