You don't need a 1/4" gap. Go for 1/8" or even just slightly less. All you need is to have some clearance for the cam to rotate from the linkage when you have the 3 point hitch raised all the way. :good2:

 

I can't get any gap when the deck is on without removing that last bolt.

 

Is your 3 point rockshaft reaching full height?

 

Wow. Ibthinkbthay may be the problem. Just had some warranty work done and they replaced that rubber washer which everyone has problems with. The 3 point lever seems real tight compared to when I took it in. The 3 point lever is all the way up. Any ideas on how to get my 3 point a little higher.

 

I don't have access to the actual procedure in the technical manual at the moment, but there is a linkage to adjust. Perhaps someone else can jump in and explain the procedure in depth. :good2:

 

Here's a post I made in another thread regarding the adjustment procedure for the rockshaft position feedback. Clicking the link should take you directly to the post:

http://www.greentractortalk.com/for...sub-compact-utility-tractors-scut/48681-1025r-rear-lift-problem.html#post705497

Puller738, take a look at the procedure I posted in the other thread so you can make sure that they are raising up to their full height.

 

I pulled out one of the bolts for a temp fix to get my gap and deck level. I have to mow and go today. Miss my old 335. May trade this thing in on another 335 this week. :bigthumb:

 

If you're referring to the washer on the hitch raise/lower level, they probably didn't get the lever adjusted correctly. There are 2 bolts that hold the lever on and one of them is in a slotted hole. Remove the RR wheel for access, loosen the bolts, move the lever so the the bolt is at the front of the slot and tighten it back up. Played the same game on mine when I replaced the washer on mine.

 

Ok. Thanks Billy. Did that prevent your 3 point from going all the way up. Out of time today so I plan on looking at it tomorrow. Thanks. Appreciate it. :bigthumb: